This page was exported from Exams Reveiew [ ]
Export date: Tue Jul 7 15:50:42 2020 / +0000 GMT

Free Cisco 300-370 Exam Dumps - [Jan_2018 Dumps]

Once you are up to appear in the Cisco Certified Network Professional Wireless 300-370 exam. You may come across a variety of websites and platforms that will be facilitating you in achieving your goal. But afterwards you will find it that only a few of them provide you assistance to pass Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 Exam. In order to pass Cisco 300-370 Exam, the most important element is to check the quality of that particular Cisco Troubleshooting Cisco Wireless Enterprise Networks exam dumps which you are selecting for dragging off your desired 300-370 certification exam.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0

Question: 21

Two 5508 Wireless Lan Controllers are managing all Access Points throughout the network

The WLCs are located in different locations to provide geographical redundancy A Mobility

Group has been configured on both WLCs and has a UP status on both Controllers The

APs m location A are statically configured to use Controller A as the Primary and Controller

B as the Secondary If the WLC in location A goes offline, the APs successfully join the

WLC m location B but they do not failover to their Primary configured Controller What

configuration task will fix this issue'

A. Change the AP Failover Priority to critical.

B. Enable AP Fallback globally on the WLC.

C. Configure the WLC in location A as Primary using the CAPWAP AP Controller IP Address command on all the location A Access Points.

D. Use DHCP Option 43 and specify WLC in location A as Primary.

Answer : C

Question: 22

An engineer is troubleshooting access point placement issues and suspects that poor

placement is causing connectivity issues When running the show client detail

command, the engineer notices this output Which option indicates poor access point


Refer to the exhibit.

A. excessive number of bytes sent compared to bytes received

B. high signal-to-noise ratio

C. excessive number of data retries

D. low ratio signal strength indicator

E. duplicate received packets

F. poor statistics for the last 90 seconds

Answer : C,D

Question: 23

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo

B. show udi

C. show inventory

D. show boot

E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational

B. major

C. minor

D. warning

E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment

B. RF detection

C. switch port tracing

D. wire detection

E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

A. debug pm pki enable

B. debug cert events enable

C. debug capwap events enable

D. debug capwap packet enable

E. debug capwap errors enable

Answer: E

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps:



Post date: 2018-01-04 01:00:00
Post date GMT: 2018-01-04 01:00:00
Post modified date: 2018-01-04 09:46:00
Post modified date GMT: 2018-01-04 09:46:00

Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team