Free Cisco 300-101 Exam Dumps – [Jan_2018 Dumps]

By | January 23, 2018

Once you are up to appear in the Cisco Certified Network Professional Routing and Switching 300-101 exam. You may come across a variety of websites and platforms that will be facilitating you in achieving your goal. But afterwards you will find it that only a few of them provide you assistance to pass Cisco Implementing Cisco IP Routing 300-101 Exam. In order to pass Cisco 300-101 Exam, the most important element is to check the quality of that particular Cisco Implementing Cisco IP Routing exam dumps which you are selecting for dragging off your desired 300-101 certification exam.

♥♥ 2018 NEW RECOMMEND 300-101 Exam Questions ♥♥

300-101 exam questions, 300-101 PDF dumps; 300-101 exam dumps:: https://www.dumpsschool.com/300-101-exam-dumps.html (429 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-101 Dumps Exam Questions and Answers:

Version: 24.0
Question: 21

A network engineer is asked to configure a “site-to-site” IPsec VPN tunnel. One of the last things that the engineer does is to configure an access list (access-list 1 permit any) along with the command ip nat inside source list 1 int s0/0 overload. Which functions do the two commands serve in this scenario?

A. The command access-list 1 defines interesting traffic that is allowed through the tunnel.
B. The command ip nat inside source list 1 int s0/0 overload disables “many-to-one” access for all devices on a defined segment to share a single IP address upon exiting the external interface.
C. The command access-list 1 permit any defines only one machine that is allowed through the tunnel.
D. The command ip nat inside source list 1 int s0/0 overload provides “many-to-one” access for all devices on a defined segment to share a single IP address upon exiting the external interface.

Answer: D

Question: 22

A network engineer is configuring a solution to allow failover of HSRP nodes during maintenance windows, as an alternative to powering down the active router and letting the network respond accordingly. Which action will allow for manual switching of HSRP nodes?

A. Track the up/down state of a loopback interface and shut down this interface during maintenance.
B. Adjust the HSRP priority without the use of preemption.
C. Disable and enable all active interfaces on the active HSRP node.
D. Enable HSRPv2 under global configuration, which allows for maintenance mode.

Answer: A

Question: 23

A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion. Which condition causes this?

A. global synchronization
B. tail drop
C. random early detection
D. queue management algorithm

Answer: A

Question: 24

Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)

A. starvation
B. jitter
C. latency
D. windowing
E. lower throughput

Answer: A, C, E

Question: 25

Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

A. dual-stack method
B. 6to4 tunneling
C. GRE tunneling
D. NAT-PT

Answer: A

Question: 26

Which statement about the use of tunneling to migrate to IPv6 is true?

A. Tunneling is less secure than dual stack or translation.
B. Tunneling is more difficult to configure than dual stack or translation.
C. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.
D. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.

Answer: C

New Updated 300-101 Exam Questions 300-101 PDF dumps 300-101 practice exam dumps: https://www.dumpsschool.com/300-101-exam-dumps.html