CCNP 300-135 Exam Dumps PDF

By | January 7, 2020

The CCNP tshoot 300-135 dumps of DumpsSchool are prepared by industry specialist. Our preparation material meets industry standards and provides candidates authentic information to prepare Cisco IP networks topics. The 300-135 tshoot exam cost of our dumps is very affordable and anyone with a desire to pass 300-135 exam can buy it to pass for better preparation.

Try it Latest DumpsSchool 300-135 Exam dumps. Buy Full File here: https://www.dumpsschool.com/300-135-exam-dumps.html (253 As Dumps)

Download the DumpsSchool 300-135 braindumps from Google Drive: https://drive.google.com/file/d/1VkqTED18kAuWO0ZDfUi2G16NXCg4otcJ/view (FREE VERSION!!!)

Question No. 1

An engineer wants to verify the access control lists that are applied on interface gigabitethernet0/0. Which

command provides the desired output?

Answer: C

Question No. 2

Which of the following characteristics describe the Root Guard feature? (Choose all that apply.)

Answer: B, D

Root guard puts the port in the root-inconsistent STP state. No traffic passes through the port in this state. After device D ceases to send superior BPDUs, the port is unblocked again. Via STP, the port goes from the listening state to the learning state, and eventually transitions to the forwarding state. Recovery is automatic; no human intervention is necessary.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00800ae96b.shtml

Question No. 3

Which of the following is an unlikely reason for the ARP process to fail?

Answer: A, D

Question No. 4

Refer to the exhibit.

PC-2 failed to establish a Telnet connection to the Terminal Server Which solution allows PC-2 to establish the Telnet connection?

Answer: A

Question No. 5

Refer to exhibit.

The tunnel between R2 and R5 is not coming up. R2, R4 and R5 do not have any routing information sources other than OSPF and no route filtering is implemented anywhere in the network. Which two actions fix the issue? (Choose Two)

Answer: A, C

In order for the tunnel to be established between R2-R5 ,the R2 should have a path for the 5.5.5.5/32 route in its own routing table , and because the ospf is the only routing protocol here , so R5 has to advertise the route 5.5.5.5/32, and that is possible through these option:

1-redistribute connected route to ospf on R5

2-Advertise interface lo0 to OSPF on R5

For knowing more about the rules for the gre channel to be established, check the link below:

http://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation-gre/118361-technote-gre-00.html

Question No. 6

A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems.

You have configured PVST+ load balancing between SW1 and the New_Switch in such a way that both the links E2/2 and E2/3 are utilized for traffic flow, which component of the configuration is preventing PVST+ load balancing between SW1 and SW2 links

Answer: D

Here is the configuration found on the New_Switch:

This causes the port cost for link eth 1/3 to increase the path cost to 250 for all VLANs, making that link less preferred so that only eth 1/2 will be used.

Question No. 7

When is uRPF desired to be applied using loose-mode for security reasons?

Answer: A

Question No. 8

Refer to the exhibit.

Which feature is required on the router to enable Unicast RPF?

Answer: B

Question No. 9

When troubleshooting recursive routing issues with GRE tunnels, which three actions resolve the issue? (Choose 3 )

Answer: C, D, E

Question No. 10

Which two conditions can be used to filter the output of the debug crypto condition command? (Choose two)

Answer: C, D

300-135 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1VkqTED18kAuWO0ZDfUi2G16NXCg4otcJ/view

Related Certification: CCNP Routing and Switching dumps